Car Fixed
GarageProLogin
2019
ford escape4 views

Check Engine Light On

Expert diagnosis and repair solutions for 2019 ford escape Check Engine Light On. Get step-by-step fixes, cost estimates, and professional advice.

Expert Repair Solutions

1
easy$0-$10
Check and tighten the gas cap to ensure it is properly sealed, which is a common cause of the check engine light.
Source: https://www.lhmforddraper.com/ford-escape-check-engine-light.htm

Repair Steps:

  1. Locate the gas cap on the fuel tank
  2. Ensure the cap is tightened until it clicks
  3. Reset the check engine light if necessary
2
medium$150-$300
Replace the O2 sensor to resolve issues related to emissions and improve engine performance.
Source: https://www.fordofwestmemphis.com/blogs/3282/ford-of-west-memphis-service/the-ford-check-engine-light-common-causes-codes-and-issues/

Repair Steps:

  1. Purchase a compatible O2 sensor for the 2019 Ford Escape
  2. Locate the faulty O2 sensor in the exhaust system
  3. Disconnect the old sensor and install the new one
  4. Clear any related diagnostic trouble codes
3
hard$2,000-$4,000
Address coolant intrusion by replacing the engine's short block and head gasket, as outlined in TSB 20-2100.
Source: https://static.nhtsa.gov/odi/tsbs/2020/MC-10174400-0001.pdf

Repair Steps:

  1. Perform a cooling system pressure test to confirm coolant intrusion
  2. Remove the engine head and inspect for damage
  3. Replace the short block and head gasket following workshop manual procedures
  4. Reassemble the engine and test for leaks
4
medium$100-$200
Inspect and replace the evaporative purge solenoid valve to fix small EVAP leaks causing the check engine light.
Source: https://www.youtube.com/watch?v=tFiibNuHTyY

Repair Steps:

  1. Locate the evaporative purge solenoid valve near the engine bay
  2. Disconnect the electrical connector and hoses
  3. Remove the old valve and install the new one
  4. Reconnect the hoses and electrical connector
5
medium$200-$400
Replace the crankcase pressure sensor to resolve DTC P051B as per TSB 19-2056.
Source: https://www.ford-trucks.com/forums/tsb_recall/tsbs/ford/escape/2022

Repair Steps:

  1. Access the crankcase pressure sensor location
  2. Remove the faulty sensor
  3. Install the new sensor
  4. Clear any stored diagnostic trouble codes

Get a Personalized Diagnosis

Get AI-powered repair suggestions specific to your vehicle's symptoms and history.

Start Free Diagnosis →
Browse more common problems