Car Fixed
GarageProLogin
2012
honda civic5 views

Check Engine Light On

Expert diagnosis and repair solutions for 2012 honda civic Check Engine Light On. Get step-by-step fixes, cost estimates, and professional advice.

Expert Repair Solutions

1
medium$150-$300
Replace the faulty oxygen sensor to resolve the check engine light issue.
Source: https://www.cogginhondadeland.com/2012-honda-civic-check-engine-light.htm

Repair Steps:

  1. Use an OBD-II scanner to confirm the oxygen sensor is faulty.
  2. Locate the faulty oxygen sensor, usually found on the exhaust manifold.
  3. Disconnect the electrical connector and remove the sensor using an appropriate wrench.
  4. Install the new oxygen sensor and reconnect the electrical connector.
  5. Clear the check engine light using the OBD-II scanner.
2
easy$10-$20
Tighten or replace the gas cap to resolve the check engine light.
Source: https://www.penskehondaindy.com/service/service-tips-and-tricks/how-to-reset-honda-check-engine-light/

Repair Steps:

  1. Inspect the gas cap for any visible damage or wear.
  2. Tighten the gas cap until it clicks to ensure a proper seal.
  3. If the cap is damaged, replace it with a new one.
  4. Drive the vehicle for a few miles to see if the check engine light turns off.
3
hard$500-$2000
Replace the catalytic converter if it is failing and causing the check engine light.
Source: https://www.autonationhondarenton.com/service/check-engine-light.htm

Repair Steps:

  1. Use an OBD-II scanner to confirm the catalytic converter is the issue.
  2. Raise the vehicle and locate the catalytic converter in the exhaust system.
  3. Remove the bolts and clamps securing the catalytic converter.
  4. Install the new catalytic converter and secure it with bolts and clamps.
  5. Lower the vehicle and clear the check engine light using the OBD-II scanner.
4
medium$100-$200
Address engine misfire by inspecting and replacing spark plugs or ignition coils.
Source: https://www.youtube.com/watch?v=dh0rEt2QQSE

Repair Steps:

  1. Use an OBD-II scanner to identify misfire codes (e.g., P0300-P0304).
  2. Inspect spark plugs for wear or damage and replace if necessary.
  3. Check ignition coils for proper function and replace faulty ones.
  4. Reassemble components and clear the check engine light using the OBD-II scanner.

Get a Personalized Diagnosis

Get AI-powered repair suggestions specific to your vehicle's symptoms and history.

Start Free Diagnosis →
Browse more common problems