Car Fixed
GarageProLogin
2014
toyota corolla4 views

Check Engine Light On

Expert diagnosis and repair solutions for 2014 toyota corolla Check Engine Light On. Get step-by-step fixes, cost estimates, and professional advice.

Expert Repair Solutions

1
medium$150-$250
Replace the faulty oxygen sensor to resolve the Check Engine Light issue.
Source: https://www.billestestoyota.com/2014-toyota-corolla-check-engine-light.htm

Repair Steps:

  1. Locate the oxygen sensor on the exhaust manifold.
  2. Disconnect the electrical connector from the sensor.
  3. Use an oxygen sensor socket to remove the faulty sensor.
  4. Install the new sensor and reconnect the electrical connector.
2
easy$10-$30
Tighten or replace the loose gas cap to turn off the Check Engine Light.
Source: https://www.autonationtoyotaarapahoe.com/service/check-engine-light.htm

Repair Steps:

  1. Inspect the gas cap for any visible damage or looseness.
  2. Tighten the gas cap securely until it clicks.
  3. If damaged, replace the gas cap with a new one.
3
medium$100-$200
Update the ECU software to address issues with the continuous variable valve lift control.
Source: https://repairpal.com/toyota/corolla/2014/check-engine-light

Repair Steps:

  1. Connect the vehicle to a diagnostic tool with the latest software update.
  2. Follow the on-screen instructions to reprogram the ECU.
  3. Verify that the Check Engine Light has been cleared after the update.
4
hard$500-$1,200
Inspect and replace the catalytic converter if it is clogged or damaged.
Source: https://www.toyotaofunioncity.com/2014-toyota-corolla-check-engine-light.htm

Repair Steps:

  1. Raise the vehicle and secure it on jack stands.
  2. Locate the catalytic converter along the exhaust system.
  3. Remove the bolts securing the catalytic converter to the exhaust system.
  4. Install the new catalytic converter and secure it with bolts.
5
mediumFree under recall
Install a noise filter between the air bag control module and its wire harness as per recall campaign 20V024000.
Source: Recall Campaign 20V024000

Repair Steps:

  1. Contact a Toyota dealer to schedule a recall service.
  2. Have the dealer inspect the ECU and install the noise filter.
  3. Verify that the Check Engine Light and airbag system are functioning correctly post-repair.

Get a Personalized Diagnosis

Get AI-powered repair suggestions specific to your vehicle's symptoms and history.

Start Free Diagnosis →
Browse more common problems